Toyota 4Runner: Precaution

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Theft Deterrent System / Precaution

PRECAUTION

1. IGNITION SWITCH EXPRESSION

HINT:

The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression	Ignition Switch (position)	Engine Switch (condition)
Ignition Switch off	Off	Off
Ignition Switch ON	ON	On (IG)
Ignition Switch ACC	ACC	On (ACC)
Engine Start	START	Start

2. NOTICE FOR ARMED STATE

If the vehicle is left in the armed state for an extended period of time or in another condition that causes the battery to be fully depleted, the alarm may sound simultaneously with the recharging of the battery or the replacement of the battery with a new one.*2 If this occurs, immediately unlock the doors through a wireless unlock operation or entry unlock operation*1 to stop the alarm.

*1: w/ Smart Key System

HINT:

*2: This may occur in the following situation: during active arming mode while in the armed state, the cable is disconnected from the negative (-) battery terminal and then reconnected (See page ).

Parts Location

PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Description

SYSTEM DESCRIPTION 1. THEFT DETERRENT SYSTEM DESCRIPTION (a) The theft deterrent system is designed to deter vehicle break-ins and theft. If an attempted break-in or theft is detected, the vehicle ...

Other materials about Toyota 4Runner:

Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) (P0776)
DESCRIPTION The ECM uses signals from the output shaft speed sensor and input speed sensor to detect the actual gear position (1st, 2nd, 3rd, 4th or 5th gear). Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mech ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after d ...