Toyota 4Runner manuals

Toyota 4Runner: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Window Defogger System

Symptom

Suspected Area

See page

Rear window defogger system does not operate

Proceed to "Rear Window Defogger System does not Operate"


Operation Check
OPERATION CHECK 1. CHECK WINDOW DEFOGGER SYSTEM OPERATION (a) When the ignition switch is turned to ON and the heater control (window defogger switch) is pressed, check that the window defogger op ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the F42 air conditioning amplifier connector. (b) Measure the voltage and resistance according to the value(s) in the ...

Other materials about Toyota 4Runner:

Initialization
INITIALIZATION 1. INITIALIZE AUTOMATIC RUNNING BOARD SYSTEM NOTICE: When a side auto step controller ECU assembly is replaced, the side auto step controller ECU assembly must be initialized. Functions such as deploying/stowing and jam protection do not ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH 3. REMOVE REAR DO ...

© 2016-2025 | www.to4runner.net

0.0064