PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Airbag System|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
SRS warning light goes off after primary check, but then comes on |
SRS Warning Light Circuit |
|
|
When ignition switch is turned to ON, SRS warning light sometimes comes on after approximately 6 seconds |
SRS Warning Light Circuit |
|
|
SRS warning light always comes on even when no DTCs are output |
SRS Warning Light Circuit |
|
|
When ignition switch is turned to ON, SRS warning light does not come on |
SRS Warning Light Circuit |
|
|
Although SRS warning light operates normally, DTC or normal system code is not output |
Diagnosis Circuit |
|
|
Although terminals TC and CG of DLC3 are not connected, DTC or normal system code is output |
Diagnosis Circuit |
|
System Description
Terminals Of EcuOn-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK SHIFT LOCK OPERATION
(a) Move the shift lever to P.
(b) Turn the ignition switch off.
(c) Check that the shift lever cannot be moved from P.
(d) Turn the ignition switch to on (IG), depress the brake pedal and che ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...