Toyota 4Runner: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FOG LIGHT COVER LH
(a) Attach the 5 claws to install the fog light cover LH.
(b) Install the outside moulding retainer.
2. INSTALL FOG LIGHT COVER RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL FOG LIGHT ASSEMBLY LH
.gif)
4. INSTALL FOG LIGHT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
5. INSTALL FRONT BUMPER REINFORCEMENT STOPPER RH (for RH Side)
(a) Attach the guide and 2 claws to install the front bumper reinforcement stopper RH.
6. INSTALL LOWER NO. 1 RADIATOR GRILLE
(a) Attach the 13 claws to install the lower No. 1 radiator grille.
(b) Install the clip.
7. INSTALL LOWER FRONT VALANCE PANEL (w/ Garnish)
(a) Install the lower front valance panel with the 13 outside moulding retainers.
8. INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
(a) Install the front bumper extension mounting bracket with the 2 screws.
9. INSTALL RADIATOR GRILLE
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE RADIATOR GRILLE
2. REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET (w/ License Plate Bracket)
(a) Remove the 2 screws to remove the front bumper extens ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
(a) ...
Other materials about Toyota 4Runner:
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt
chart (See page ).
PROC ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK / CLEAR (when Using Techstream)
(a) Check for DTCs.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Cod ...
0.0259