Toyota 4Runner: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
.gif)
2. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
3. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
4. INSTALL NO. 2 INSTRUMENT PANEL WIRE
(a) Attach the 17 clamps to install the No. 2 instrument panel wire.
(b) Connect the connector.
5. INSTALL TELLTALE LIGHT ASSEMBLY
6. INSTALL ACCESSORY METER ASSEMBLY
7. INSTALL DEFROSTER NOZZLE ASSEMBLY
(a) Install the defroster nozzle assembly with the 3 screws.
8. INSTALL NO. 3 HEATER TO REGISTER DUCT
(a) Attach the claw.
(b) Install the No. 3 heater to register duct with the 2 screws.
9. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
(a) Attach the 2 claws.
(b) Install the No. 2 side defroster nozzle duct with the screw.
10. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT
(a) Attach the 2 claws.
(b) Install the No. 1 side defroster nozzle duct with the screw.
11. INSTALL NO. 2 HEATER TO REGISTER DUCT
(a) Install the No. 2 heater to register duct with the 4 screws.
12. INSTALL NO. 1 HEATER TO REGISTER DUCT
(a) Install the No. 1 heater to register duct with the 4 screws.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 HEATER TO REGISTER DUCT
(a) Remove the 4 screws and No. 1 heater to register duct.
2. REMOVE NO. 2 HEATER ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
(a) Attach ...
Other materials about Toyota 4Runner:
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH
(a) Pack the upper arm ball joint with MP grease.
Grease capacity:
8.0 g (0.282 oz.)
Text in Illustration
*1
MP Grease
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REFRESHING SEAT SWITCH
Text in Illustration
*a
Component without harness connected
(Refreshing Seat Switch)
*b
Blower
*c
Heater
*d
...
0.0275