Toyota 4Runner: Scanning radio stations (excluding XM® Satellite Radio)
Scanning the preset radio stations
Press and hold
until you hear a beep.
Preset stations will be played for 5 seconds each.
When the desired station is
reached, press 
again.
Scanning all radio stations within range
Press
.
All the stations with reception will be played for 5 seconds each.
When the desired station is
reached, press again.
Displaying radio text messages (for type B and C, FM mode only)
When a new radio text message is received, “MSG” is shown on the display. To
display the message, press 
.
If the text continues past the end of the display, “
” is displayed. Press and hold 
until you hear a beep.
Text messages are not displayed while driving.
Setting station presets (excluding XM® Satellite Radio)
Search for desired stations by
turning
or
or pressing “∧” or “∨” on
.
Press and hold a button (from
to
) until you hear a beep.
Type B and C: Each time is
pressed, station ...
XM® Satellite Radio (if equipped)
Receiving XM® Satellite Radio
Press
or
.
The display changes as follows each time
or
is pressed.
Type A: AM → SAT1 → SAT2 → SAT3 Type B and C: AM → FM → SAT
Turn
or
to selec ...
Other materials about Toyota 4Runner:
Navigation Receiver Assembly Power Source Circuit
DESCRIPTION
This is the power source circuit to operate the navigation receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCE ...
4WD Control ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
4WD Control ECU Communication Stop Mode
Either condition is met:
"Four Wheel Drive Control" is not displayed on the "Bus ...
0.0069