Toyota 4Runner: Sending Malfunction (Navigation to APGS) (U0073,U0140)

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / Sending Malfunction (Navigation to APGS) (U0073,U0140)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the CAN communication circuit.

DTC No.	DTC Detection Condition	Trouble Area
U0073	CAN bus connection error	CAN communication system
U0140	CAN reception error	CAN communication system

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

GO TO CAN COMMUNICATION SYSTEM

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System DTC Code Detection Item See page B1532 LVDS Signal Malfunction (from Extension Modu ...

XM Tuner Antenna Disconnected (B15FE,B15FF)

DESCRIPTION These DTCs are stored when a malfunction occurs in the satellite radio antenna assembly which is connected to the stereo component tuner assembly. DTC No. DTC Det ...

Other materials about Toyota 4Runner:

Automatic Disconnecting Differential Actuator
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR (a) Remove any old FIPG material. NOTICE: Be careful not to drop oil on the contact surfaces of the actuator and clut ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY (a) Remove the rear No. 2 seat assembly (See page ). 2. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board) 3. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board) 4. REMOVE NO. 2 LUG ...