Toyota 4Runner manuals

Toyota 4Runner: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.

CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that the mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.


OK

END

NG

2.

CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.


OK

END

NG

3.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

MALFUNCTION IN PORTABLE PLAYER

Confirm Vehicle Headunit Functionality
PROCEDURE 1. CHECK CUSTOMER'S CELLULAR PHONE COMPATIBILITY (a) Go to TIS "Bluetooth" Compatibility Portal and check if the cellular phone is compatibl ...

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary. HINT: ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE JACK BOX HOLE COVER 2. REMOVE REAR QUARTER PANEL MUDGUARD LH 3. REMOVE REAR QUARTER PANEL MUDGUARD RH HINT: Use the same procedure as for the LH side. 4. REMOVE REAR BUMPER COVER 5. REMOVE NO. 3 FLOOR WIRE 6. RE ...

Inspection
INSPECTION PROCEDURE 1. INSPECT WIRELESS DOOR LOCK BUZZER (a) Measure the resistance according to the value(s) in the table below. HINT: The buzzer activation circuit is built into the ECU, not into the buzzer itself. When battery volta ...

© 2016-2023 | www.to4runner.net

0.102