Toyota 4Runner manuals

Toyota 4Runner: Rear window and outside rear view mirror defoggers

Defoggers are used to defog the rear window, and to remove raindrops, dew and frost from the outside rear view mirrors.

Before operating the defoggers, make sure the back window is completely closed.

Vehicles with a manual air conditioning system


Turns the defoggers on/off

The defoggers will automatically turn off after their operation time. The operation time varies depending on the ambient temperature and vehicle speed.

Vehicles with an automatic air conditioning system


Turns the defoggers on/off

The defoggers will automatically turn off after their operation time. The operation time varies depending on the ambient temperature and vehicle speed.

The defoggers can be operated when

• Vehicles without a smart key system:

The engine switch is in the “ON” position.

Vehicles with a smart key system:

The “ENGINE START STOP” switch is in IGNITION ON mode.

• The back window is completely closed.

The outside rear view mirror defoggers

Turning the rear window defogger on will turn the outside rear view mirror defoggers on.

CAUTION

When the outside rear view mirror defoggers are on

Do not touch outside surface of the rear view mirrors, as they can become very hot and burn you.

Adjusting the position of and opening and closing the air outlets
Front center outlets 1. Direct air flow to the left or right, up or down. 2. Turn the knob to open or close the vent. Front side outlets 1. Direct air flow to the left or right, up or down. 2 ...

Windshield wiper de-icer
This feature is used to prevent ice from building up on the windshield and wiper blades. Turns the windshield wiper deicer on/off The windshield wiper de-icer will automatically turn off after a ...

Other materials about Toyota 4Runner:

Active traction control system
The active traction control system automatically helps prevent the spinning of 4 wheels when the vehicle is started or accelerated on slippery road surfaces. System operation Part-time 4WD models: Stop the vehicle, shift the shift lever to N and shift ...

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DOME RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...

© 2016-2024 | www.to4runner.net

0.0078