Toyota 4Runner: AUTO LSD Indicator Light does not Come ON

Toyota 4Runner Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / AUTO LSD Indicator Light does not Come ON

DESCRIPTION

The AUTO LSD does not operate even if the VSC OFF switch is pressed under the following conditions:

The brake system is faulty.
The temperature inside the hydraulic brake booster increases and the AUTO LSD operation is suspended.

WIRING DIAGRAM

Refer to AUTO LSD Indicator Light Remains ON (See page ).

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page ).

PROCEDURE

1.	CHECK CAN COMMUNICATION LINE

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Turn the Techstream on.

(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page ).

OK:

CAN Bus Check indicates no malfunctions in CAN communication.

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.	INSPECT VSC OFF SWITCH

REPLACE VSC OFF SWITCH

3.	CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.	READ VALUE USING TECHSTREAM (AUTO LSD INDICATOR LIGHT)

REPLACE MASTER CYLINDER SOLENOID

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

A-TRAC Indicator Light Remains ON

DESCRIPTION This is the A-TRAC main switch circuit. When the A-TRAC switch is turned on with the transfer in L4, the A-TRAC function is available and the A-TRAC indicator light illuminates. WIRI ...

A-TRAC Indicator Light does not Come ON

DESCRIPTION The A-TRAC does not operate even if the A-TRAC switch is pressed under the following conditions: The TRAC or VSC system is faulty. The temperature inside the hydraulic brake ...

Other materials about Toyota 4Runner:

Short in Telephone Antenna Circuit (B1573,B15CB)
DESCRIPTION This DTC is stored when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna circuit. The DCM (Telematics Transceiver) sends and receives signals at a radio frequency of between 824 and 894 MHz or 1850 ...

Transmitter Battery(w/o Smart Key System)
Replacement REPLACEMENT CAUTION / NOTICE / HINT NOTICE: Take extra care when handling these precision electronic components. PROCEDURE 1. REMOVE TRANSMITTER HOUSING COVER (a) Twist a screwdriver in the direction of the arrow in the illustra ...