Toyota 4Runner: AUTO LSD system (2WD models)
The AUTO LSD system aids traction by using the traction control system to control engine performance and braking when one of the rear wheels begins to spin.
The system should be used only when wheel spinning occurs in a ditch or rough surface.
System operation
Press the VSC off switch to turn on the system.
At this time, the “AUTO LSD” and VSC off indicators will come on.
To turn off the system, press the switch again.
When the AUTO LSD system is operating
If the rear wheels spin, the slip indicator flashes to indicate that the AUTO LSD system has controlled the spinning of the rear wheels.
If the engine is turned off and restarted
The AUTO LSD system and the indicators are automatically turned off.
If the brake system overheats
The system will cease operation and a buzzer will sound to alert the driver.
At this time, the “AUTO LSD” indicator will flash and the “TRAC OFF” indicator will come on. Stop the vehicle in a safe place. (There is no problem with continuing normal driving.)
The system will be automatically restored after a short time.
CAUTION
To avoid an accident
• Do not use the AUTO LSD system in conditions other when wheel spinning occurs in a ditch or rough surfaces.
A much greater steering effort and more careful cornering control will be required.
• Do not drive with the AUTO LSD system continuously turned on.
NOTICE
Activating while driving
Never activate the AUTO LSD system if the wheel is slipping.
Stop the slipping or spinning before activating.
Active traction control system
The active traction control system automatically helps prevent the
spinning of 4 wheels when the vehicle is started or accelerated on slippery road
surfaces.
System operation
Part-time 4WD mode ...
Rear differential lock system
The rear differential lock system is provided for use only when wheel
spinning occurs in a ditch or on a slippery or rugged surface.
The rear differential lock system is effective in case one of th ...
Other materials about Toyota 4Runner:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK STEERING PAD (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page
).
(b) With the steering pad installed on the vehicle, perform a visual check. If
there are any defects as mention ...
Moving a second row seat for access to the third row seats (vehicles with
third row seats)
Getting in the vehicle (right side only)
Pull up the lever and fold down the seatback. The seat will slide forward.
Move the seat to the front-most position.
Getting out of the vehicle (right side only)
Lift the lever on the back of the seatback and fo ...
0.0263