Toyota 4Runner: Automatic Running Board Ecu

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FLOOR SIDE SILL STAY ...

Precaution

PRECAUTION 1. PRECAUTION FOR SIDE AUTO STEP ECU (a) When the side auto step controller ECU assembly is replaced, the side auto step controller ECU assembly must be initialized (See page ). ...

Other materials about Toyota 4Runner:

Shifting between H2 and H4
Shifting from H2 to H4 Type A Reduce vehicle speed to less than 50 mph (80 km/h). Shift the front-wheel drive control lever to H4. Type B Reduce vehicle speed to less than 62 mph (100 km/h). Push the “UNLOCK” button and turn the front-whee ...

Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve and drain the following amount of oil from the new compressor and magnet ...