Toyota 4Runner: Body

Toyota 4Runner Service Manual / General / Maintenance / Body

General Maintenance

GENERAL MAINTENANCE

PROCEDURE

1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY

(a) Where necessary, tighten all the parts of the chassis.

Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
Engine mounting, etc.

(b) Where necessary, tighten all parts of the body.

Seat belt system
Seat
Doors and hood
Body mounting
Fuel tank
Exhaust pipe system, etc.

2. REPLACE AIR CONDITIONING FILTER

(a) Remove the air conditioning filter (See page ).

(b) Visually inspect the surface of the air conditioning filter.

3. TIRE ROTATION

4. FINAL INSPECTION

(a) Check the operation of the body parts.

(1) Hood

Auxiliary catch operates properly.
Hood locks securely when closed.

(2) Front and rear doors

Door locks operate properly.
Doors close properly.

(3) Back door

Door lock operates properly.

(4) Seats

Seat adjusts easily and locks securely in any position.
Front seatback locks securely in any position.
Rear seatback locks securely in any position.
Folding-down rear seatbacks lock securely.

(5) Be sure to deliver a clean vehicle. Especially check:

Steering wheel
Shift lever knob
All switch knobs
Door handles
Seats

Brake

General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT BRAKE LINE PIPES AND HOSES HINT: Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning th ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INS ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...