Toyota 4Runner: CD cannot be Ejected

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / CD cannot be Ejected

PROCEDURE

1.	CHECK OPERATION

(a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected.

OK:

CD is ejected.

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.	REPLACE CD AND RECHECK

(a) Replace the CD with a known good one and check that the malfunction disappears.

OK:

CD is ejected.

CD WAS FAULTY

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

Sound Quality is Bad Only when CD is Played (Volume is Too Low)

PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK ...

CD cannot be Inserted / Played or CD is Ejected Right After Insertion

PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, st ...

Other materials about Toyota 4Runner:

Operating the system using voice commands
By following voice guidance instructions output from the speaker, voice commands enable to the operation of the Bluetooth® audio system without the need to check the display or operate . Operation procedure when using voice commands Press the talk swit ...

Side Auto Step Switch Circuit
DESCRIPTION The side auto step controller ECU assembly receives the door open/closed signal from each door courtesy light switch via the side auto step switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT HINT: Inspection should be performed on the ...