Toyota 4Runner: Components

Front Door Belt Moulding

...

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Other materials about Toyota 4Runner:

Crawl Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE DRIVE MONITOR SWITCH (CRAWL CONTROL SWITCH AND MULTI-TERRAIN SELECT SWITCH) (a) Detach the 4 claws and remove the drive monitor switch (CRAWL control switch an ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (a) Install a new gasket and the differential carrier assembly with the 10 nuts and 10 washers. Torque: 52 N·m {530 kgf·cm, 38 ft·lbf} 2. INSTALL REAR AXLE SHAFT LH (a) Install t ...