Toyota 4Runner: Components

Side Moulding

...

Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT FENDER OUTSIDE ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (a) Attach the 2 claws to install the sensor. (b) Connect the connector. 2. INSTALL NO. 3 HEATER TO REGISTER DUCT 3. INSTALL NO. 1 SI ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT DUST COVER (a) Using SST and a press, install a new dust cover. SST: 09527-10011 2. INSTALL SHAFT SNAP RING (a) Install a new snap ring. 3. INSTALL OUTBOARD JOINT BOOT HINT: Before installing the ...