COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
RemovalInspection
INSPECTION
PROCEDURE
1. INSPECT TRANSFER INPUT SHAFT
(a) Using a micrometer, measure the diameter of the input shaft journal.
Minimum diameter:
47.59 mm (1.88 in.)
If the diameter is less than the minimum, replace the input shaft.
(b) Usin ...
Hydraulic Test
HYDRAULIC TEST
1. PERFORM HYDRAULIC TEST
(a) Measure the line pressure.
CAUTION:
The line pressure test should always be carried out in pairs. One technician
should observe the conditions of the wheels and wheel stoppers from outside the
vehicle while ...