CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Utility / Customize Setting.
(e) Select the setting by referring to the table below.
Seat Belt Warning|
Display |
Default |
Contents |
Setting |
|---|---|---|---|
|
Driver Side Seatbelt Warning Buzzer |
ON |
If the driver side seat belt is unfastened and the vehicle is driven at approximately 20 km/h (12.5 mph) or more, the system sounds the seat belt warning buzzer. |
ON or OFF |
|
Front Passenger Side Seatbelt Warning Buzzer |
ON |
If the front passenger side seat belt is unfastened with the front passenger seat occupied and the vehicle is driven at approximately 20 km/h (12.5 mph) or more, the system sounds the seat belt warning buzzer. |
ON or OFF |
System Description
Operation CheckRear Door LH ECU Communication Stop (B2324)
DESCRIPTION
This DTC is stored when LIN communication between the rear power window regulator
motor assembly LH and main body ECU (multiplex network body ECU) stops for 10 seconds
or more.
DTC Code
DTC Detection Condition
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of code, refer to the "See page" below.
CAN Communication System
DTC Code
De ...