Toyota 4Runner: Seat Belt Warning System

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is sh ...

Precaution

PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Hold the drive shaft lightly in a vise between aluminum plates. (b) Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / DTC. (e) Read the DTCs. 2. CLEAR DTC (a) Connect ...