Toyota 4Runner: Diagnosis System

Toyota 4Runner Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Diagnosis System

DIAGNOSIS SYSTEM

1. CHECK DLC3

(a) Check the DLC3 (See page ).

Terminals Of Ecu

TERMINALS OF ECU 1. COMBINATION METER ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color ...

DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON and turn the Techstream on. (c) Enter the following menus: Body Electrical / Trouble Codes ...

Other materials about Toyota 4Runner:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (Using SST Check Wire) (a) Check for DTCs (present trouble code). (1) Turn the ignition switch to ON and wait for approximately 60 seconds. (2) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3. SST: 09843-18040 N ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT DUST COVER (a) Using SST and a press, install a new dust cover. SST: 09527-10011 2. INSTALL SHAFT SNAP RING (a) Install a new snap ring. 3. INSTALL OUTBOARD JOINT BOOT HINT: Before installing the ...