Toyota 4Runner: Operation Check
OPERATION CHECK
1. CHECK SEAT CUSHION CLIMATE CONTROL BLOWER
(a) Turn the engine switch on (IG).
(b) Set the refreshing seat switch blower side to level 3 (maximum).
(c) Check that the fan motor turns smoothly.
2. CHECK SEATBACK CLIMATE CONTROL BLOWER
(a) Turn the engine switch on (IG).
(b) Set the refreshing seat switch blower side to level 3 (maximum).
(c) Check that the fan motor turns smoothly.
3. CHECK SEAT HEATER
(a) Turn the engine switch on (IG).
(b) When the refreshing seat switch is turned on, check that the indicator light illuminates, and that the seat surface warms up in approximately 5 minutes.
(c) When the refreshing seat switch's volume switch is operated, check that the seat surface temperature changes.
System Diagram
SYSTEM DIAGRAM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are lis ...
Other materials about Toyota 4Runner:
Short in Telephone Antenna Circuit (B1573,B15CB)
DESCRIPTION
This DTC is stored when the DCM (Telematics Transceiver) detects an open or a
short in the telephone and GPS antenna circuit. The DCM (Telematics Transceiver)
sends and receives signals at a radio frequency of between 824 and 894 MHz or 1850
...
Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422)
DESCRIPTION
Refer to DTCs C1421, C1423 and C1424 (See page
).
DTC Code
DTC Detection Condition
Trouble Area
C1422
When the stop light switch assembly is off, the PM/C1 terminal voltage
is 0.8 ...
0.0267