Toyota 4Runner: Diagnostic Trouble Code Chart

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Cellular Communication / Safety Connect System / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.

Safety Connect System

DTC Code	Detection Item	See page
B1570	Manual (SOS) Switch Red Indicator Malfunction
B1571	Manual (SOS) Switch Green Indicator Malfunction
B1572	Telephone Microphone Error
B1573	Short in Telephone Antenna Circuit
B1583	GPS Signal Unreceived
B15A8	Telematics Transceiver Malfunction
B15C0	Short in GPS Antenna
B15C1	Open in GPS Antenna
B15C4	Airbag Signal Malfunction/Not Input
B15C5	Manual Button Malfunction
B15CB	Telematics Transceiver Antenna Disconnected
B15CC	Backup Battery Failure
B15EC	Backup Battery Degradation

Backup Battery Degradation (B15EC)

DESCRIPTION This DTC is stored when the DCM (Telematics Transceiver) detects either of the following conditions. The BUB (Back-Up Battery) charge level becomes less than the criteria. ...

Backup Battery Failure (B15CC)

DESCRIPTION This DTC is stored when the DCM (Telematics Transceiver) detects one of the following: Open or short in the BUB (Back-Up Battery) circuit. The BUB (Back-Up Battery) voltage dr ...

Other materials about Toyota 4Runner:

Rear Occupant Classification Sensor RH Collision Detection (B1788)
DESCRIPTION DTC B1788 is stored when the occupant classification ECU receives a collision detection signal, which is sent by the occupant classification sensor rear RH when an accident occurs. DTC B1788 is also stored when the separate type front seat cu ...

Stabilizer Control Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. N ...