Toyota 4Runner: Backup Battery Degradation (B15EC)

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Cellular Communication / Safety Connect System / Backup Battery Degradation (B15EC)

DESCRIPTION

This DTC is stored when the DCM (Telematics Transceiver) detects either of the following conditions.

The BUB (Back-Up Battery) charge level becomes less than the criteria.
Automatic Collision Notification (ACN) was performed.

When this DTC is stored, the BUB (Back-Up Battery) must be replaced. BUB (Back-Up Battery) degradation DTC B15EC is not reported in the deactive mode.

DTC Code	DTC Detection Condition	Trouble Area
B15EC	The BUB (Back-Up Battery) is deteriorated.	BUB (Back-Up Battery)

CAUTION / NOTICE / HINT

NOTICE:

If this DTC is stored, be sure to replace the BUB (Back-Up Battery) with a new one.
After the BUB (Back-Up Battery) is replaced, it is necessary to clear this DTC.

PROCEDURE

1.	CHECK FOR DTC

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Perform "Health Check" and check for current DTCs (See page ).

Result

Result	Proceed to
DTC B15EC is output	A
DTC B15EC is not output	B

REPLACE BUB (BACK-UP BATTERY)

CHECK FOR INTERMITTENT PROBLEMS

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the valves listed under "Normal Condition" are reference values. Do not depend solely on these reference values when dec ...

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" bel ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (a) Using a center punch, mark the center of the tapered-head bolt. (b) Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 2 bolts. (c) Using a screw extractor, remo ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC HINT: When DTC B1650/32 is stored as a result of troubleshooting for the airbag system, perform troubleshooting for the occupant classification system. (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch t ...