Toyota 4Runner: Disposal

Toyota 4Runner Service Manual / Suspension / Suspension Control / Stabilizer Control Valve(w/ Kdss) / Disposal

DISPOSAL

PROCEDURE

1. DISPOSE OF STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

(a) Using a drill, make a hole in the areas of the accumulator housing indicated in the illustration to discharge the gas inside.

CAUTION:

Be careful and always use the proper safety equipment when drilling because shards of metal may fly about.
The gas is colorless, odorless and non-poisonous.

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Suspension Control System(w/ Kdss)

...

Other materials about Toyota 4Runner:

Short to B+ in CAN Bus Line
DESCRIPTION There may be a short circuit between the CAN bus lines and +B when the resistance between terminals 6 (CANH) and 16 (BAT) or terminals 14 (CANL) and 16 (BAT) of the DLC3 is below 6 kΩ. Symptom Trouble Area ...

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) When the ultrasonic sensors detect any obstacles at the corners and rear of the vehicle, the system informs the driver of the distance between the sensors and the obstacles by sounding a buzzer. 2. FUNCTION OF COMPONENT ...