Toyota 4Runner: Suspension Control System(w/ Kdss)

Disposal

DISPOSAL PROCEDURE 1. DISPOSE OF STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY (a) Using a drill, make a hole in the areas of the accumulator housing indicated in the illustra ...

Precaution

PRECAUTION 1. Kinetic Dynamic Suspension System CAUTION: Be sure to check the pipe connections and whether or not any hydraulic circuit parts are damaged before performing work as the h ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after d ...

Power Source Mode does not Change to ON (IG)
DESCRIPTION When the engine switch is pushed with the key in the cabin, the power management control ECU receives signals to switch the power source mode. WIRING DIAGRAM Refer to "Power Source Mode does not Change to on (IG and ACC)" (See page ...