Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System(for Manual Air Conditioning System) / Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK FOR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

(e) Check for DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

(e) Clear the DTCs.

Data List / Active Test

DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Ambient Temperature Sensor Circuit (B1412)

DESCRIPTION The cooler thermistor (ambient temperature sensor) is installed in the front part of the cooler condenser assembly. This sensor is connected to the air conditioning amplifier assembly ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 3 FLOOR WIRE (a) Disconnect the 4 connectors and remove the 3 pieces of tape. (b) Detach the 4 clamps to remove the No. 3 floor wire. 2. REMOVE REAR BUMPER SIDE BRACKET LH (a) Remove the clip and 2 screws. ...

Radio Antenna Cord
Components COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termin ...