Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Engine Immobiliser System(w/ Smart Key System) / Dtc Check / Clear

DTC CHECK / CLEAR

HINT:

When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
Refer to the Techstream operator's manual for further details.

1. CHECK FOR IMMOBILISER DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Check for DTCs.

2. CHECK FOR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Check for DTCs.

3. CLEAR IMMOBILISER DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Clear the DTCs.

4. CLEAR ECM DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

(e) Clear the DTCs.

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" bel ...

Theft Deterrent System Communication Line High Fixation (B279A)

DESCRIPTION If the communication line (EFIO-IMI) to the ID code box is stuck on HI output, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area ...

Other materials about Toyota 4Runner:

Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the Techstream to check for malfunctions and to perform r ...

Installation
INSTALLATION PROCEDURE 1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY (a) Using a vernier caliper and straightedge, measure dimension "A" between the transmission fitting surface of the engine*1 and the torque converter clutch fitting surface o ...