Toyota 4Runner manuals

Toyota 4Runner: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Read the DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Clear the DTCs.

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use these procedures to troubleshoot the smart key system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY (a) Using a T25 "TORX" socket wrench, install the back power window regulator motor assembly with the 3 screws. HINT: Tighten the sc ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER LINK ASSEMBLY (a) Install the rear stabilizer link assembly with the bolt and nut. Torque: 100 N·m {1020 kgf·cm, 74 ft·lbf} HINT: Turn the nut while holding the bolt. 2. INSTALL REAR STABILIZER CONT ...

© 2016-2026 | www.to4runner.net

0.0133