Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Interior / Power Outlets (int) / Voltage Inverter / Removal

REMOVAL

PROCEDURE

1. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

2. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)

3. REMOVE REAR DOOR SCUFF PLATE RH

4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board)

6. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board)

7. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ Deck Board)

8. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

9. REMOVE REAR NO. 2 FLOOR BOARD ASSEMBLY (w/ Deck Board)

10. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH (w/ Deck Board)

11. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH (w/ Deck Board)

12. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

13. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

14. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)

15. REMOVE REAR NO. 1 SEAT LAP BELT OUTER ANCHOR COVER

16. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

17. REMOVE FRONT DECK SIDE TRIM COVER RH

18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

19. REMOVE VOLTAGE INVERTER ASSEMBLY

(a) Disconnect the 2 connectors.

(b) Remove the 3 bolts and voltage inverter.

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT VOLTAGE INVERTER ASSEMBLY HINT: Remove interior parts so that the voltage inverter can be seen. (a) Disconnect the voltage inverter connector ...

Installation

INSTALLATION PROCEDURE 1. INSTALL VOLTAGE INVERTER ASSEMBLY (a) Install the voltage inverter with the 3 bolts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (b) Connect the 2 connectors. 2. INSTAL ...

Other materials about Toyota 4Runner:

Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Check for DTCs (Click here ). ...

Operation Check
OPERATION CHECK 1. CHECK NAVIGATION SYSTEM NORMAL CONDITION (a) If the symptom is applicable to any of the following, it is intended behavior, and not a malfunction. Symptom Answer A longer route than expected is cho ...