Toyota 4Runner: Dtc Check / Clear

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Park Assist / Monitoring / Rear View Monitor System(for Navigation Receiver Type) / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Check for DTCs (Click here ).

NOTICE:

The navigation receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

System	Proceed to
Navigation System

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Clear the DTCs.

Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, u ...

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Rear View Monitor System DTC No. Detection Item Link C1622 Back Camera Disconnected ...

Other materials about Toyota 4Runner:

Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor, spiral cable and steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very usefu ...