DESCRIPTION
These DTCs are stored when a malfunction occurs in the navigation antenna assembly.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B15C0 |
Navigation antenna error |
|
|
B15C1 |
Error of the power source to the navigation antenna |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
|
|
2. |
CHECK CONNECTION OF NAVIGATION ANTENNA CORD |
(a) Check if the navigation antenna cord is securely connected to the radio and display receiver assembly.
OK:
Navigation antenna cord is securely connected.
| NG | |
SECURELY CONNECT NAVIGATION ANTENNA CORD |
|
|
3. |
INSPECT NAVIGATION ANTENNA ASSEMBLY |
(a) Remove the navigation antenna assembly (See page
).
(b) Inspect the navigation antenna assembly (See page
).
| OK | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | |
REPLACE NAVIGATION ANTENNA ASSEMBLY |
Speaker Output Short (B15C3)
XM Tuner Malfunction (B15BA)Detection range of the sensors
1. Approximately 1.6 ft. (50 cm) 2. Approximately 4.9 ft. (150 cm)
The diagram shows the detection range of the sensors. Note that the sensors
cannot detect obstacles that are extremely close to the vehicle.
The range of the sensors may change depending ...
Diagnosis System
DIAGNOSIS SYSTEM
1. SYMPTOM SIMULATION
HINT:
The most difficult case in troubleshooting is when no problem symptoms occur.
In such a case, a thorough problem analysis must be carried out. A simulation of
the same or similar conditions and environment in ...