Toyota 4Runner: XM Tuner Malfunction (B15BA)

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / XM Tuner Malfunction (B15BA)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the stereo component tuner assembly.

DTC Code	DTC Detection Condition	Trouble Area
B15BA	When either of the conditions below is met: Internal IC malfunction Tuner malfunction	Stereo component tuner assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check if the same DTCs are output again.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE STEREO COMPONENT TUNER ASSEMBLY

GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 ...

AV Signal Stoppage (Low Battery Voltage) (B158F)

DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC No. ...

Other materials about Toyota 4Runner:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the F42 air conditioning amplifier connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) ...

Open in ABS Solenoid Relay Circuit (C0278,C0279)
DESCRIPTION The solenoid relay is built into the master cylinder solenoid. This relay supplies power to each solenoid. If the initial check is OK, after the ignition switch is turned to ON, the relay turns on. DTC Code DTC Detection ...