DESCRIPTION
These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B1551 |
When one of the conditions below is met:
|
Radio and display receiver assembly |
|
B158D |
The internal video signal of the radio and display receiver assembly is interrupted |
|
|
B15A0 |
When either condition below is met:
|
|
|
B15B0 |
Picture circuit (TFT unit) malfunction |
|
|
B15B3 |
When one of the conditions below is met:
|
|
|
B15B4 |
When one of the conditions below is met:
|
|
|
B15B7 |
"Bluetooth" module malfunction |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page
).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
LVDS Signal Malfunction (from Extension Module) (B1532)
Satellite Radio Broadcast cannot be ReceivedInspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
(a) Check the seat cushion heater.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
...
Open Circuit in Transfer 4WD Position Switch Circuit (C1258,C1340)
DESCRIPTION
DTC Code
DTC Detection Condition
Trouble Area
C1258*1
C1340*2
An open circuit is detected in the EXI circuit of the skid control ECU.
Harness or connector
...