Toyota 4Runner: High Engine Revolution Signal (C1544)

Toyota 4Runner Service Manual / Steering / Power Assist Systems / Power Steering System / High Engine Revolution Signal (C1544)

DESCRIPTION

The power steering ECU assembly receives engine speed signals from the ECM via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the engine speed signal.

DTC Code	DTC Detection Condition	Trouble Area
C1544	An abnormal engine speed signal is received.	SFI system CAN communication system Power steering ECU assembly

PROCEDURE

1.	CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)

(a) Check if DTC U0100 is output (See page ).

Result

Result	Proceed to
DTC U0100 is not output	A
DTC U0100 is output	B

HINT:

DTC U0100 indicates a CAN communication malfunction in the power steering system.

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.	CHECK OTHER DTC OUTPUT (SFI SYSTEM)

(a) Using the Techstream, check for DTCs and confirm that there are no problems in the SFI system (See page ).

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

REPLACE POWER STEERING ECU ASSEMBLY

GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

Vehicle Speed Signal (C1541)

DESCRIPTION The power steering ECU assembly receives vehicle speed signals from the master cylinder solenoid (skid control ECU) via CAN communication. The power steering ECU assembly provides app ...

Power Steering Warning Light Circuit

DESCRIPTION The power steering ECU assembly is connected to the combination meter assembly via CAN communication. If the power steering ECU assembly detects a malfunction, the power steering warn ...

Other materials about Toyota 4Runner:

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. CHECK REAR AIRBAG SENSOR LH (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform ...

Inspection
INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL TRANSMITTER MODULE (a) Inspect the operation of the transmitter. (1) Remove the battery (lithium battery) from the transmitter (See page ). (2) Install a new or normal battery (lithium battery). ...