Toyota 4Runner: Red Indicator Remains On

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Cellular Communication / Safety Connect System / Red Indicator Remains On

DESCRIPTION

This means that the DCM (Telematics Transceiver) detects a malfunction in the Safety Connect and stores a DTC.

PROCEDURE

1.	CHECK FOR DTC

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Perform "Health Check" and check for current DTCs (See page ).

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.	REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (Telematics Transceiver) (See page ).

NOTICE:

The ignition switch must be off.
Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

PERFORM DCM ACTIVATION

Green Indicator Remains Off

DESCRIPTION After the ignition switch is turned to ON, the DCM (Telematics Transceiver) will enter a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn ...

Unable To Connect To Call Center

DESCRIPTION This may occur when the intensity of the telephone radio frequency was very weak, PRL updates are required or the Safety Connect system has a malfunction, and a DTC is stored. PROCED ...

Other materials about Toyota 4Runner:

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. DRAIN AUTOMATIC TRANSMISSION FLUID 2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY 3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY 4. DISCONNECT TRANSMISSION WIRE 5. REMOVE TRANSMISSION VALVE BODY ASSEMBLY (a) Remove th ...