Toyota 4Runner: Power Steering System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- VFC Solenoid Circuit (C15F0)
- Steering Angle Sensor Circuit (C15F1)
- Lost Communication with ECM / PCM "A" (U0100,U0126,U0129)
- Vehicle Speed Signal (C1541)
- High Engine Revolution Signal (C1544)
- Power Steering Warning Light Circuit
- IG Power Source Circuit
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Attach t ...
Precaution
PRECAUTION
1. EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications
of the vehicle.
The expressions listed in the table below are u ...
Other materials about Toyota 4Runner:
Wireless remote control
The wireless remote control can be used to lock and unlock the vehicle.
Vehicles without a smart key system
1. Locks all the doors
2. Sounds the alarm (press and hold)
3. Unlocks all the doors Pressing the button unlocks the driver’s door. Pressing
...
Power Source Control ECU Malfunction (B2782)
DESCRIPTION
The steering lock ECU activates the steering lock motor with the power from the
power management control ECU through the IGE circuit. This prevents the steering
from being locked while the vehicle is moving.
If NG (PAST) is displayed for Powe ...
© 2016-2026 | www.to4runner.net
0.0272
0.0272