CAUTION / NOTICE / HINT
HINT:
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Check if the LIN communication system is functioning normally.
|
Result |
Proceed to |
|---|---|
|
LIN DTC is not output |
A |
|
LIN DTC is output |
B |
| B | |
GO TO LIN COMMUNICATION SYSTEM |
|
|
4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to the Problem Symptoms Table (See page
).
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B | |
GO TO STEP 6 |
|
|
5. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU (See page
).
(b) Data List / Active Test (See page
).
|
|
6. |
ADJUST, REPAIR OR REPLACE |
|
|
7. |
CONFIRMATION TEST |
| NEXT | |
END |
System Description
Customize ParametersIllumination for Panel Switch does not Come on with Tail Switch ON
PROCEDURE
1.
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal
in Operation Check (See page ).
(b) Check that the display changes between ON ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER DRYER
(a) Using pliers, install the cooler dryer.
(b) Apply a sufficient amount of compressor oil to the contact surfaces
of a new O-ring and the cap.
Compressor oil:
ND-OIL 8 or equivalent
...