Toyota 4Runner: Customize Parameters

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Customize Parameters

CUSTOMIZE PARAMETERS

1. CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)

HINT:

The following items can be customized.

NOTICE:

When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Customize.

(e) Select the setting by referring to the table below.

Wiper

Display	Default	Content	Setting
Linked Rear Wiper Washer	AVAIL	Function to make the rear wiper run automatically after the washer function is used.	NOT AVAIL or AVAIL
Rewipe Function	AVAIL	Function to make the rear wiper run once automatically for a certain amount of time after the washer function is completed to prevent the dripping of washing fluid.	NOT AVAIL or AVAIL
Rear Wiper Interval Speed	3 sec.	Function used to change the time from when the rear wiper stops moving until it starts moving again in intermittent mode.	3 sec., 2 sec., 4 sec. or 5 sec.
Rear Wiper Retract Time	3 sec.	Function used to change the time from when the rear wiper stops moving after the rear wiper switch is turned off until the rear wiper is stored in the spoiler.	3 sec., 4 sec., 5 sec. or 6 sec.

How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUG ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials about Toyota 4Runner:

System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Combination meter assembly Main body ECU (Multiplex network body ECU) Vehicle speed signal CAN ...

Yaw Rate Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Yaw Rate Sensor Communication Stop Mode Either condition is met: "Yaw Rate / Deceleration Sensor" is not displayed on the &quo ...