CAUTION / NOTICE / HINT
HINT:
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Check if the CAN communication system is functioning normally (See page
).
|
Result |
Proceed to |
|---|---|
|
CAN DTC is not output |
A |
|
CAN DTC is output |
B |
| B | |
GO TO CAN COMMUNICATION SYSTEM |
|
|
4. |
CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the LIN communication system is functioning normally.
|
Result |
Proceed to |
|---|---|
|
LIN DTC is not output |
A |
|
LIN DTC is output |
B |
| B | |
GO TO LIN COMMUNICATION SYSTEM |
|
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table (See page
).
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in problem symptoms table |
A |
|
Fault is listed in problem symptoms table |
B |
| B | |
GO TO STEP 7 |
|
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check (See page
).
(b) Terminals of ECU (See page
).
(c) Data List / Active Test (See page
).
|
|
7. |
ADJUST, REPAIR OR REPLACE |
|
|
8. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
System DescriptionPressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT) (P2714)
DESCRIPTION
The linear solenoid valve (SLT) controls the transmission line pressure for smooth
transmission operation based on signals from the throttle position sensor and vehicle
speed sensor. The ECM adjusts the duty ratio* of the SLT solenoid valve ...
Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly
to the radio and display receiver assembly.
If there is an open in the circuit, the radio system cannot be operated using
the steering pad switch assembly.
If there ...