Toyota 4Runner: How To Proceed With Troubleshooting

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Wireless Door Lock Control System(w/o Smart Key System) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
Use these procedures to troubleshoot the wireless door lock control system.
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

3.	CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output (See page ).

(b) Clear the DTCs (See page ).

(c) Recheck for DTCs. Based on the DTCs output above, try to force output of the same LIN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.

Result	Proceed to
DTC is not output	A
LIN communication system DTC is output	B
Wireless door lock control system DTC is output	C

GO TO LIN COMMUNICATION SYSTEM

GO TO DIAGNOSTIC TROUBLE CODE CHART

4.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page
).

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

GO TO STEP 6

5.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Operation Check (See page ).

(b) Terminals of ECU (See page ).

6.	REPAIR OR REPLACE

7.	CONFIRMATION TEST

END

System Description

SYSTEM DESCRIPTION 1. WIRELESS DOOR LOCK CONTROL SYSTEM DESCRIPTION (a) This system locks/unlocks the vehicle doors remotely. The wireless control system has the following features: The do ...

Operation Check

OPERATION CHECK 1. NOTICES WHEN CHECKING (a) Wireless door lock/unlock function: This function operates only when the vehicle is in its initial condition (the following 3 conditions are met). ...

Other materials about Toyota 4Runner:

Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION When the front doors are closed, each power window regulator motor can control its power window operation for approximately 43 seconds after the ignition switch is turned from ON to off by receiving operation permission signals ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ign ...