Toyota 4Runner: Initialization
INITIALIZATION
1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
NOTICE:
- After the battery is reconnected, be sure to wait 10 seconds or more before attempting to start the engine. The engine may not start immediately after the battery is reconnected.
- If the necessary procedure is not performed, the back door cannot be opened or closed.
(a) Perform an unlock operation with the door control switch of the multiplex network master switch with the back door closed.
Operation Check
OPERATION CHECK
1. CHECK POWER DOOR LOCK OPERATION
NOTICE:
The operation check below is based on the non-customized initial condition of
the vehicle.
(a) Check basic functions.
(1) Check that a ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are lis ...
Other materials about Toyota 4Runner:
Operating the system using voice commands
By following voice guidance instructions output from the speaker, voice
commands enable to the operation of the Bluetooth® audio system without the need
to check the display or operate .
Operation procedure when using voice commands
Press the talk swit ...
Display Signal Circuit between Navigation Receiver Assembly and Television Camera
Assembly
DESCRIPTION
This is the display signal circuit between the navigation receiver assembly and
the television camera assembly.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - REAR TELEVISION
...
0.0268