Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Washer Motor(for Front Side) / Inspection

INSPECTION

PROCEDURE

1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

(a) Remove the washer jar.

(b) Disconnect the windshield washer motor and pump connector.

HINT:

Make sure that the windshield washer motor and pump is installed to the washer jar.

(d) Connect the positive (+) lead of the battery to terminal 1 of the windshield washer motor and pump and the negative (-) lead to terminal 2.

(e) Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.

If the result is not as specified, replace the washer motor and pump assembly.

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Installation

INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Install the windshield washer motor and pump assembly to the packing of the washer jar. 2. INSTALL WASHER JAR ...

Other materials about Toyota 4Runner:

Rear No. 2 Seat Inner Belt Assembly
Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL REAR NO. 2 SEAT INNER BELT SUB-ASSEMBLY (a ...

Disc cannot be Ejected
CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE 1. CHECK OPERATION (a) Press ...