Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Power Source / Network / Power Distribution / Power Management Control Ecu / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL POWER MANAGEMENT CONTROL ECU

(a) Attach the 2 claws to install the power management control ECU.

2. INSTALL ECU INTEGRATION BOX RH

(a) Install the ECU integration box RH with the 2 nuts and bolt.

(b) Attach the clamp.

NOTICE:

Do not twist the connectors of the ECU when connecting them.
Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY

4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

5. INSTALL INSTRUMENT PANEL BOX DOOR COVER

6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

7. INSTALL LOWER INSTRUMENT COVER LH

8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

HINT:

Use the same procedure described for the No. 1 instrument cluster finish panel garnish.

(a) Install the No. 2 instrument cluster finish panel garnish (See page ).

10. INSTALL COWL SIDE TRIM BOARD RH

(a) Attach the clip and claw to install the cowl side trim board.

(b) Install the clip.

11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

(a) Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the Techstream to check for malfunctions and to perform r ...

BUS IC Communication Malfunction (B1497/97)
DESCRIPTION The air conditioning harness assembly connects the No. 1 air conditioning amplifier assembly and each servo motor. The No. 1 air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the ai ...

Toyota 4Runner: Installation

Removal

Power Assist Systems

Other materials about Toyota 4Runner: