Toyota 4Runner: Power Management Control Ecu

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL MULTIPLEX NETWORK BODY ECU NOTICE: ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT PROPELLER SHAFT ASSEMBLY (a) Using a dial indicator, check the propeller shaft runout. Maximum runout: 0.4 mm (0.0157 in.) If the shaft runout is more than the maximum, replace the shaft. ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER LINK ASSEMBLY (a) Install the rear stabilizer link assembly with the bolt and nut. Torque: 100 N·m {1020 kgf·cm, 74 ft·lbf} HINT: Turn the nut while holding the bolt. 2. INSTALL REAR STABILIZER CONT ...