Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Suspension / Front Suspension / Front Upper Suspension Arm / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH

(a) Temporarily install the suspension upper arm and 2 washers with the bolt and nut.

HINT:

After stabilizing the suspension, tighten the nut.

(b) Connect the bracket with the bolt.

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

Torque:

110 N·m {1122 kgf·cm, 81 ft·lbf}

2. INSTALL SKID CONTROL SENSOR WIRE

3. INSTALL FRONT WHEEL

Torque:

for aluminum wheel :

103 N·m {1050 kgf·cm, 76 ft·lbf}

for steel wheel :

112 N·m {1142 kgf·cm, 83 ft·lbf}

4. STABILIZE SUSPENSION

5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH

(a) Tighten the nut.

Torque:

115 N·m {1173 kgf·cm, 85 ft·lbf}

6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment (See page ).

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH (a) Pack the upper arm ball joint with MP grease. Grease capacity: 8.0 g (0.282 oz.) Text in Illustration ...

Other materials about Toyota 4Runner:

Cautions & Notices
CAUTION This is a warning against something which, if ignored, may cause death or serious injury to people. You are informed about what you must or must not do in order to reduce the risk of death or serious injury to yourself and others. NOTICE This i ...

Operation Check
OPERATION CHECK 1. CHECK SEAT CUSHION CLIMATE CONTROL BLOWER (a) Turn the engine switch on (IG). (b) Set the refreshing seat switch blower side to level 3 (maximum). (c) Check that the fan motor turns smoothly. 2. CHECK SEATBACK CLIMATE CONTROL BLOWER (a ...

Toyota 4Runner: Installation

Reassembly

Rear Suspension

Other materials about Toyota 4Runner: