Toyota 4Runner: Reassembly

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Back Door Outside Garnish / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

When installing the back door outside garnish seal, heat the back door outside garnish surface using a heat light.

Standard:

Item	Temperature
Back Door Outside Garnish	20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the back door outside garnish excessively.

PROCEDURE

1. INSTALL BACK DOOR CONTROL SWITCH (w/ Smart Key System)

2. INSTALL NO. 1 BACK DOOR GARNISH RETAINER (w/o Smart Key System)

(a) Install the No. 1 back door garnish retainer with the screw.

3. INSTALL BACK DOOR OUTSIDE GARNISH SEAL

(a) Clean the back door outside garnish surface.

(1) Using a heat light, heat the back door outside garnish surface.

(2) Remove the double-sided tape from the back door outside garnish surface.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Install a new back door outside garnish seal.

(1) Remove the peeling paper from the face of a new back door outside garnish seal.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(2) Install the back door outside garnish seal.

4. INSTALL LICENSE PLATE LIGHT ASSEMBLY

5. INSTALL NO. 2 BACK DOOR OUTSIDE GARNISH

(a) Attach the 2 clips to install the No. 2 back door outside garnish.

6. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY 2. REMOVE NO. 2 BACK DOOR OUTSIDE GARNISH (a) Detach the 2 clips and No. 2 back door outside garnish. 3. REMOVE LICENSE PLATE ...

Installation

INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE GARNISH (w/o Smart Key System) (a) Attach the 3 clips to install the back door outside garnish. (b) Install the 4 nuts. (c) Connect the connect ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL REAR NO. 2 SPOILER CLIP HINT: Use the same procedure to install the rear No. 2 spoiler clip on the ...

Speed Sensor Circuit Malfunction (C1883/83)
DESCRIPTION The stabilizer control ECU receives the speed signal from the skid control ECU via CAN communication. DTC Code DTC Detection Condition Trouble Area C1883/83 The stabilizer control ECU ...