INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
2. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL FRONT BUMPER SIDE SUPPORT LH
4. INSTALL FRONT BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
5. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH
6. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
7. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
(a) Install the front bumper reinforcement sub-assembly with the 6 nuts and screw.
Torque:
Nut :
30 N·m {306 kgf·cm, 22 ft·lbf}
8. INSTALL FRONT BUMPER ENERGY ABSORBER
9. INSTALL RADIATOR SIDE DEFLECTOR LH
10. INSTALL RADIATOR SIDE DEFLECTOR RH
11. INSTALL AIR INTAKE DUCT LH
(a) Install the air intake duct LH with the 2 screws.
(b) Install the clip and bolt.
12. INSTALL AIR INTAKE DUCT RH
HINT:
Use the same procedure as for the LH side.
13. INSTALL FRONT BUMPER LOWER COVER
(a) Install the front lower bumper cover with the 4 bolts and clip.
14. INSTALL COOL AIR INTAKE DUCT (for 4WD)
(a) Install the cool air intake duct with the 4 clips.
15. INSTALL UPPER CENTER FRONT BUMPER RETAINER
16. INSTALL FRONT BUMPER COVER
(a) Connect the 3 connectors.
(b) Attach the 14 claws to install the front bumper cover with radiator grille.
(c) Install the 3 bolts, 10 screws and 6 clips.
17. INSTALL UPPER RADIATOR SUPPORT SEAL
18. ADJUST FOG LIGHT AIMING
(See page )
Diagnosis System
DIAGNOSIS SYSTEM
1. SYMPTOM SIMULATION
HINT:
The most difficult case in troubleshooting is when no problem symptoms occur.
In such a case, a thorough problem analysis must be carried out. A simulation of
the same or similar conditions and environment in ...
Jam Protection Function does not Operate
DESCRIPTION
This problem may occur in all door windows.
The jam protection function operates within a specified range during
the manual up or auto up operation.
PROCEDURE
1.
PERFORM INITIALIZATION
(a) ...