Toyota 4Runner: Front Bumper(w/ Intuitive Parking Assist System)

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH (a) ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Short to B+ in CAN Bus Line
DESCRIPTION There may be a short circuit between the CAN bus lines and +B when the resistance between terminals 6 (CANH) and 16 (BAT) or terminals 14 (CANL) and 16 (BAT) of the DLC3 is below 6 kΩ. Symptom Trouble Area ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 3 FLOOR WIRE (a) Disconnect the 4 connectors and remove the 3 pieces of tape. (b) Detach the 4 clamps to remove the No. 3 floor wire. 2. REMOVE REAR BUMPER SIDE BRACKET LH (a) Remove the clip and 2 screws. ...