Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Front Door Belt Moulding / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT DOOR BELT MOULDING LH

(a) Attach the 6 claws to install the front door belt moulding.

2. INSTALL FRONT DOOR GLASS RUN LH

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

5. INSTALL FRONT DOOR SERVICE HOLE COVER LH

6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

8. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Front Door Window Frame Moulding

...

Other materials about Toyota 4Runner:

Transmitter ID not Registered (C2171/71)
DESCRIPTION The ID of each tire pressure warning valve and transmitter is registered to the tire pressure warning ECU. When the ECU detects that a transmitter ID code is not registered in the ECU, this DTC is stored. DTC Code Detec ...

Removal
REMOVAL PROCEDURE 1. REMOVE JACK BOX HOLE COVER 2. REMOVE REAR QUARTER PANEL MUDGUARD LH 3. REMOVE REAR QUARTER PANEL MUDGUARD RH HINT: Use the same procedure as for the LH side. 4. REMOVE REAR BUMPER COVER (a) Remove the 2 bolts and 2 screws. ...