Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Door Belt Moulding / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING LH

(a) Attach the 7 claws to install the rear door belt moulding.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

3. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

5. INSTALL REAR DOOR GLASS RUN LH

6. INSTALL REAR DOOR SERVICE HOLE COVER LH

7. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

9. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Rear Door Window Frame Moulding

...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INS ...

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR AXLE SHAFT (a) Using a dial indicator, measure the rear axle shaft runout and flange runout. Maximum runout: Shaft runout: 1.50 mm (0.0591 in.) Flange runout: 0.05 mm (0.00197 in.) If the rear axle shaft or flange ...